BLHeli_32 firmware is the third generation of BLHeli firmware, following base BLHeli and BLHeli_S.
Supports up to 48K PWM frequency, so the response speed is faster and smoother, reducing mid-throttle oscillations.
Equipped with double-sided lightweight metal armor to avoid hardware damage caused by crashes, and the armor can effectively assist the MOSFET to dissipate heat.
Double PCB board design, high current circuit, and signal circuit are independent of each other.
All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also causing active freewheeling.
Supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us) and Multishot (5-25us).
Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power-up, No need for throttle calibration.
All codes use damped light mode. Damped light mode does regenerative braking, causing very fast motor retardation, and inherently also causing active freewheeling.
Supports beacon functionality, where the ESC will start beeping after a given time of zero throttles. This can be very useful for finding a lost drone.
SPECIFICATIONS
Rated Current: 60A
Peak Current: 70A
Input Voltage: 3-6S Lipo
PWM FREQ: 24-48KHz
Weight:15.5g
Dimension: 43.5*33*9mm
BL32 FW: RUSH_BLADE_RACING
INCLUDES
1 x RUSHFPV Rush Blade Racing 32Bit 60A 3-6S 48kHz 20x20 4in1 ESC